Dyna-Glo Delux KFA650DGD Use and Care Manual download pdf (Page 8)

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

TO STOP HEATER

TO RESTART HEATER

1. Wait until cooling cycle is finished after stopping heater.

2. Repeat steps under to start HEATER.

The cooling cycle cools the combustion chamber.

CAUTION ; Never unplug heater while heater is running

Heater must go through cooling cycle. The cooling cycle cools the

combustion chamber. Damage to heater can occur if combustion chamber

is not cooled. Do not restart heater until cooling cycle is complete.

CAUTION ; Do not restart heater until cooling cycle is finished.

1. Turn operating switch to “OFF”.

This will cause heater flame to go out.

The motor will continue to run during the cooling cycle.

(Room Temp. Display will show “CC” during the cooling cycle)

This allows the fan to cool the combustion chamber. When the cooling cycle

(approx.1Min) is finished, the motor will stop.

Do not unplug heater until cooling cycle is finished.

2. Unplug power cord.

3. To temporarily stop heaters, set thermostat at a temperature lower than air around heater,

Heater will cycle back on if air temperature around heater matches thermostat setting.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

No comments

Dyna-Glo Delux KFA650DGD Use and Care Manual Page 8